Used filters (1)  Zrušit všechna omezení
Number of found documents: 34356
Published from to

Galloping of insulated bundled overhead line simplified analysis
Hračov, Stanislav; Macháček, Michael
2024 - English
Our paper provides an analysis of the susceptibility of a particular bundled overhead line to galloping. It presents a case study of an aerial bundled cable, consisting of four conductors insulated by polyethylene, and used for low-voltage power lines. The susceptibility to loss of stability is analyzed for cable without and with simulated icing observed on similar real conductors. In the first case, the proneness to galloping was excluded based on the results of CFD simulation and the Den Hartog criterion. In latter case, the possible occurrence of galloping was confirmed. The critical wind velocity for the ice-covered cable was calculated utilizing quasi-steady theory. Finally, the amplitudes of limit cycle oscillation for supercritical wind speeds were estimated based on simplified numerical analysis. Keywords: aerial bundled cable; wind effects; galloping; limit cycle oscillation Available in digital repository of the ASCR
Galloping of insulated bundled overhead line simplified analysis

Our paper provides an analysis of the susceptibility of a particular bundled overhead line to galloping. It presents a case study of an aerial bundled cable, consisting of four conductors insulated by ...

Hračov, Stanislav; Macháček, Michael
Ústav teoretické a aplikované mechaniky, 2024

LES simulations of airflow around rectangle with side ratio 2:1 and their comparison with experiments
Ledvinková, Blanka; Hračov, Stanislav; Macháček, Michael
2024 - English
Our contribution is focused on the comparison of the experimental investigations and of the numerical 3D LES simulations of the airflow around sharply edged rectangle with side ratio 2:1. The rectangle object was exposed to the airflow having a given velocity at different angles of the wind attack in the wind tunnel with the aim to obtain the curves of the aerodynamic coefficients and Strouhal number depending on the impact angle. The comparative numerical 3D simulations of the wind tunnel testing were performed using COMSOL Multiphysics and OpenFoam both incorporating the Large Eddy Simulation (LES) method. Keywords: rectangle 2:1; wind tunnel; LES simulation; aerodynamic characteristics Available in digital repository of the ASCR
LES simulations of airflow around rectangle with side ratio 2:1 and their comparison with experiments

Our contribution is focused on the comparison of the experimental investigations and of the numerical 3D LES simulations of the airflow around sharply edged rectangle with side ratio 2:1. The ...

Ledvinková, Blanka; Hračov, Stanislav; Macháček, Michael
Ústav teoretické a aplikované mechaniky, 2024

A New Hollow Fiber-Based Liquid-Phase Microextraction Method for the Determination of Antihypertensive Drug Lercanidipine in Biological Samples
Labzova, O.; Hrdlička, Vojtěch; Navrátil, Tomáš; Šelešovská, R.
2024 - English
A new hollow fiber-based liquid-phase microextraction (HF-LPME) method for the determination of antihypertensive drug lercandipine (LCN) in biological samples was developed. HF-LPME was\ncombined with optimized square wave voltammetry (SWV) on a cathodically pre-treated screenprinted boron-doped diamond electrode (SP-BDDE). Optimum HF-LPME conditions were:\nsupported liquid membrane (SLM) dodecane, 0.02 mol L-1 Britton-Robinson buffer (BRB, pH = 3) acceptor phase, BRB (pH = 7) donor phase, and time of extraction 30 min. Limits of quantification (LOQ) and detection (LOD) were 3.3 and 1.1 nmol L-1, respectively. The applicability of the developed method was verified on human urine, blood serum, and blood plasma with 20 and 100 nmol L-1 LCN addition. Keywords: Lercanidipine hydrochloride; Hollow fiber liquid-phase microextraction; Screenprinted boron-doped diamond electrode Available on request at various institutes of the ASCR
A New Hollow Fiber-Based Liquid-Phase Microextraction Method for the Determination of Antihypertensive Drug Lercanidipine in Biological Samples

A new hollow fiber-based liquid-phase microextraction (HF-LPME) method for the determination of antihypertensive drug lercandipine (LCN) in biological samples was developed. HF-LPME was\ncombined with ...

Labzova, O.; Hrdlička, Vojtěch; Navrátil, Tomáš; Šelešovská, R.
Ústav fyzikální chemie J. Heyrovského, 2024

Culture in numbers 2023
Dedera, Milan; NIPOS, Národní informační a poradenské středisko pro kulturu
2024 - Czech
Statistika kultury se zabývá zjišťováním údajů o činnosti kulturních subjektů (např. návštěvnost, kapacita, vzdělávací akce, vydané publikace, výpůjčky, čtenáři). V předkládané brožuře jsou zveřejněny vybrané údaje za následující obory: divadlo, galerie, muzea a památníky, hvězdárny, planetária a astronomické pozorovatelny, veřejné knihovny, památkové objekty zpřístupněné za vstupné, neperiodické publikace a periodický tisk. Údaje ekonomické povahy jsou k dispozici pouze za subjekty veřejného sektoru, kulturní subjekty v soukromém sektoru je neposkytují. Keywords: divadelní představení; galerie; hudební tělesa; knihovny; kultura a společnost; muzea; nakladatelství; návštěvnost; památkové objekty; statistika; umění a společnost; výstavnictví; ancient monuments; art and society; culture and society; ensembles; galleries; libraries; museums; numbers of visitors; organization of exhibitions; publishing houses; statistics; theatrical perfomances Available in a digital repository NRGL
Culture in numbers 2023

Statistika kultury se zabývá zjišťováním údajů o činnosti kulturních subjektů (např. návštěvnost, kapacita, vzdělávací akce, vydané publikace, výpůjčky, čtenáři). V předkládané brožuře jsou zveřejněny ...

Dedera, Milan; NIPOS, Národní informační a poradenské středisko pro kulturu
NIPOS, 2024

Gas sensors based on diamond heterostructures for air quality monitoring
Kočí, Michal; Szabó, Ondrej; Izsák, T.; Sojková, M.; Godzierz, M.; Wróbel, P.; Husák, M.; Kromka, Alexander
2024 - English
Currently, great emphasis is placed on air quality and the presence of pollutants. Attention is therefore focused on new gas-sensing materials enabling detection even at low (up to room) temperatures with sufficient response and short reaction time. Here, we investigate the suitability of H-NCD films and their heterostructures with MoS2, GO, rGO, SH-GO, or Au NPs for gas sensing applications. Electrical properties are measured for oxidizing gas NO2, reducing gas NH3, and chemical vapor of ethanol, and at temperatures varied from room temperature to 125 °C. In contrast to the individual forms of employed materials with limited response to the exposed gases, the HNCD heterostructures revealed better sensing properties. In particular, the Au NPs/H-NCD heterostructures revealed a higher response at 125 °C in contrast to H-NCD, MoS2/H-NCD had quite good response even at room temperature and GO/H-NCD revealed high sensitivity to chemical vapor, which further improved for the SH-GO/HNCD. Keywords: gas sensors; nanocrystalline diamond; heterostructures; air quality monitoring Fulltext is available at external website.
Gas sensors based on diamond heterostructures for air quality monitoring

Currently, great emphasis is placed on air quality and the presence of pollutants. Attention is therefore focused on new gas-sensing materials enabling detection even at low (up to room) temperatures ...

Kočí, Michal; Szabó, Ondrej; Izsák, T.; Sojková, M.; Godzierz, M.; Wróbel, P.; Husák, M.; Kromka, Alexander
Fyzikální ústav, 2024

Development of Polymeric Enantioselective Membranes
Čížek, Jan
2024 - English
Enantiomers are molecules that share the same chemical formula but in space form mirror images of each other. Their reactions with other chiral molecules can be remarkably different, which is crucial mainly for pharmaceuticals and agrochemicals. However, industrialscale synthetic production of enantiomerically pure compounds is not always available. Therefore, the need for pure enantiomeric compounds drives the development and research on various separation methods. However, most methods used on the industrial scale are limited to specific compounds (diastereomeric recrystallization) or generally difficult and/or expensive to scale up (chromatography-related methods). Separation of enantiomers using membranes is promising\nthanks to the easy scalability and continuous operation of membrane processes. Various ideas about how the enantioselective membranes should look like have been published in the last thirty years. The mechanism of enantiomeric separation on a membrane is, however, highly specific, and still requires extensive research. In this work, four types of enantioselective polymeric membranes are presented. Available in a digital repository NRGL
Development of Polymeric Enantioselective Membranes

Enantiomers are molecules that share the same chemical formula but in space form mirror images of each other. Their reactions with other chiral molecules can be remarkably different, which is crucial ...

Čížek, Jan
Ústav chemických procesů, 2024

Synthesis of Fluorinated Methyl β-Lactosides
Krčil, Aleš
2024 - English
In my contribution, I will describe the synthesis of a complete series of mono-deoxyfluorinated methyl β-lactosides (1–7). Their affinity towards hgals will be determined by analytical method ELISA. The synthesis relies on monosaccharide building blocks, which serves as key intermediates that are transformed into the target products through glycosylation followed by final deprotection steps. Keywords: flurinated carbohydrates; galectin; deoxyfluorination Available in a digital repository NRGL
Synthesis of Fluorinated Methyl β-Lactosides

In my contribution, I will describe the synthesis of a complete series of mono-deoxyfluorinated methyl β-lactosides (1–7). Their affinity towards hgals will be determined by analytical method ELISA. ...

Krčil, Aleš
Ústav chemických procesů, 2024

Investigation of Mechanical Processing of Solar Photovoltaic Panels
Šperlich, Antonín
2024 - English
This work aims to describe the possibilities of mechanical treatment of solar photovoltaic panels. In the first part, the shredding and milling process for the transformation of the product (whole panel) into material that can be further processed, was investigated. Milled material was sieved and analyzed. It was observed that this shredding also works as a selective grinding because three main products were produced. The second part of this work was aimed at the physical concentration of silver in real samples of milled solar photovoltaic panels by Knelson separator. This device (type of centrifugal separator) showed the ability to significantly increase the amount of silver in the outcome stream. Keywords: solar photovoltaic panels; selective milling; Knelson Available in a digital repository NRGL
Investigation of Mechanical Processing of Solar Photovoltaic Panels

This work aims to describe the possibilities of mechanical treatment of solar photovoltaic panels. In the first part, the shredding and milling process for the transformation of the product (whole ...

Šperlich, Antonín
Ústav chemických procesů, 2024

Axial Dispersion and Mass Transfer in Bubble Column
Terentyak, Mark
2024 - English
The objective of the study is to experimentally investigate axial dispersion and mass transfer within a bubble column, examining their mutual interrelation\nand their correlation with operational parameters and AR1. Keywords: bubble column; axial dispersion; mass transfer Available in a digital repository NRGL
Axial Dispersion and Mass Transfer in Bubble Column

The objective of the study is to experimentally investigate axial dispersion and mass transfer within a bubble column, examining their mutual interrelation\nand their correlation with operational ...

Terentyak, Mark
Ústav chemických procesů, 2024

Exploring Bubble Dynamics with VOF Method Simulations: Insights from Two Fundamental Gas-Liquid Flow Case Studies
Harrandt, Václav
2024 - English
The present study focuses on the flow of Taylor bubbles, representing the interaction between the channel wall and the gas phase, and the collision of\na bubble with a vortex ring, serving as a model liquid-gas interaction. Understanding the former case can be essential to prevent the membrane\nfouling or the flow induced corrosion. The dynamics of the latter case is the predictive criterion for whether the initial mother bubble will break up into the daughter bubbles or not2 and this process can therefore be used as an idealized model of turbulent bubble flow. Keywords: bubble dynamics; multiphase interaction,; numerical simulation Available in a digital repository NRGL
Exploring Bubble Dynamics with VOF Method Simulations: Insights from Two Fundamental Gas-Liquid Flow Case Studies

The present study focuses on the flow of Taylor bubbles, representing the interaction between the channel wall and the gas phase, and the collision of\na bubble with a vortex ring, serving as a model ...

Harrandt, Václav
Ústav chemických procesů, 2024

About project

NRGL provides central access to information on grey literature produced in the Czech Republic in the fields of science, research and education. You can find more information about grey literature and NRGL at service web

Send your suggestions and comments to nusl@techlib.cz

Provider

http://www.techlib.cz

Facebook

Other bases