Ne (7633)
Ano (1654)
Počet nalezených dokumentů:
9287
Publikováno od
do
Galloping of insulated bundled overhead line - nonlinear numerical analysis in time domain
Macháček, Michael; Hračov, Stanislav
2024 - anglický
Our contribution focuses on a 3D numerical nonlinear analysis of galloping in a specific bundled overhead line with ice accretion. We studied the susceptibility to this self-excited oscillation, critical onset wind speeds, and global dynamic response of a very low-tensioned line with simulated icing observed on similar real conductors. Due to the highly nonlinear mechanical behavior of such a flexible cable, we employed the Newmark integration method combined with the iterative Newton-Raphson method. We analyzed two numerical models of the overhead line loaded by the wind: one assuming nonlinearity only in the wind load, while retaining the linearity of the mechanical system itself, and the other representing a fully nonlinear system including geometrical nonlinearity. Our analysis revealed that the determined critical wind speeds for the onset of galloping are in relatively close ranges for both models. However, numerical simulations with the fully nonlinear system indicated significantly lower amplitudes of limit cycle oscillations, especially at higher wind speeds, compared to the linear model of the line. This underscores the necessity of using fully nonlinear models during the design stage of such low-tensioned aerial conductors.
Klíčová slova:
aerial bundled conductors; wind effects; galloping; limit cycle oscillation
Plné texty jsou dostupné v digitálním repozitáři Akademie Věd.
Galloping of insulated bundled overhead line - nonlinear numerical analysis in time domain
Our contribution focuses on a 3D numerical nonlinear analysis of galloping in a specific bundled overhead line with ice accretion. We studied the susceptibility to this self-excited oscillation, ...
Applicable Adaptive Discounted Fully Probabilistic Design of Decision Strategy
Molnárová, Soňa
2024 - anglický
The work addresses the issue of decreased utility of future rewards, referred to as discounting, while utilizing fully probabilistic design (FPD) of decision strategies. FPD obtains the optimal strategy for decision tasks using only probability distributions, which is its main asset. The standard way of solving decision tasks is provided by Markov decision processes (MDP), which FPD covers as a special case. Methods of solving discounted MDPs have already been introduced. However, the use of FPD might be advantageous when solving tasks with an unknown system model. Due to its probabilistic nature, FPD is able to obtain a more precise estimation of this model. After previously introducing discounting and system model estimation to FPD, the current work examines the effect of discounting on decision processes and its possible advantages when dealing with an unknown system model.
Klíčová slova:
Bayesian estimation; decision making; discounting; forgetting; probabilistic strategy design; supression of aproximate modelling impact
Dokument je dostupný na externích webových stránkách.
Applicable Adaptive Discounted Fully Probabilistic Design of Decision Strategy
The work addresses the issue of decreased utility of future rewards, referred to as discounting, while utilizing fully probabilistic design (FPD) of decision strategies. FPD obtains the optimal ...
Numerical study of the steady airflow in the human respiratory system during inhaling and exhaling
Lancmanová, Anna; Bodnár, Tomáš
2024 - anglický
This paper presents some of the initial results of the numerical simulations of a steady turbulent flow in human upper airways during inhalation and exhalation. The mathematical model is based on the system of Reynolds-Averaged incompressible Navier-Stokes equations complemented by the SST k − ω turbulence model. The simulations were performed using finite-volume open source solver OpenFOAM on a realistic three-dimensional geometry. The main aim of this particular study is to verify the computational setup with special focus on appropriate choice and implementation of boundary conditions. The prescribed boundary conditions are chosen to mimic the physiological conditions during normal breathing cycle. This study aims to gain an insight into the airflow behavior during the inhalation and exhalation process by comparing the results of two distinct simulations corresponding to two different (opposite) flow rates . The obtained local flow rates and flow fields for both cases are presented and mutually compared. This initial work should serve as a foundation for future more complex simulations that will include the time-dependent and compressible effects.
Klíčová slova:
human airways; incompressible Navier-Stokes; OpenFOAM
Plné texty jsou dostupné v digitálním repozitáři Akademie Věd.
Numerical study of the steady airflow in the human respiratory system during inhaling and exhaling
This paper presents some of the initial results of the numerical simulations of a steady turbulent flow in human upper airways during inhalation and exhalation. The mathematical model is based on the ...
Verification of the dynamic properties of a new model turbine wheel with free blades
Voronova, Evgeniya; Procházka, Pavel; Maturkanič, Dušan; Mekhalfia, Mohammed Lamine; Hodboď, Robert
2024 - anglický
The paper describes a new experimental model of turbine wheel with free blades. Verification tests were carried out using a Doppler laser vibrometer, with a focus on the equipment parameters under various conditions. The measurements were performed in the Laboratory of Rotational Laser Vibrometry originated at the Institute of Thermomechanics AS CR, v.v.i.
Klíčová slova:
natural frequencies; vibration; blade; laser; turbine
Plné texty jsou dostupné na jednotlivých ústavech Akademie věd ČR.
Verification of the dynamic properties of a new model turbine wheel with free blades
The paper describes a new experimental model of turbine wheel with free blades. Verification tests were carried out using a Doppler laser vibrometer, with a focus on the equipment parameters under ...
Numerical evaluation of mass-diffusive compressible fluids flows models
Bodnár, Tomáš; Fraunié, P.
2024 - anglický
This contribution presents first numerical tests of some recently published alternative models for solution of viscous compressible and nearly incompressible models. All models are solved by high resolution compact finite difference scheme with strong stability preserving RungeKutta time stepping. The two simple but challenging computational test cases are presented, based on the double-periodic shear layer and the Kelvin-Helmholtz instability. The obtained time-dependent flow fields are showing pronounced shear and vorticity layers being resolved by the standard as well as by the new mass-diffusive modified models. The preliminary results show that the new models are viable alternative to the well established classical models.
Klíčová slova:
compressible Navier-Stokes; nearly incompressible flow; mass diffusion; compact finite-difference
Plné texty jsou dostupné v digitálním repozitáři Akademie Věd.
Numerical evaluation of mass-diffusive compressible fluids flows models
This contribution presents first numerical tests of some recently published alternative models for solution of viscous compressible and nearly incompressible models. All models are solved by high ...
Motion of fluids in the moving domain
Nečasová, Šárka
2024 - anglický
It is a survay paper where the problem of the existence of weak solutions of compressible barotropic solutions in a moving bounded domain is studied.
Klíčová slova:
compressible fluid; moving domain; weak solutions
Plné texty jsou dostupné v digitálním repozitáři Akademie Věd.
Motion of fluids in the moving domain
It is a survay paper where the problem of the existence of weak solutions of compressible barotropic solutions in a moving bounded domain is studied.
PROPERTIES OF NANOCRYSTALLINE FE-NI PARTICLES PREPARED BY THERMAL REDUCTION OF OXALATE PRECURSORS
Švábenská, Eva; Roupcová, Pavla; Havlíček, Lubomír; Schneeweiss, Oldřich
2024 - anglický
Recent technological advancements require development of cost-effective and high-performance magnets \nwhich ideally do not contain rare earth metals or noble metals. The promising candidates are Fe-Ni-based \nalloys, in particular, the Fe50Ni50 L10 phase (tetrataenite), which has a great perspective for producing hard \nmagnetic materials. Our study explores a promising method for preparing nanoparticles of Fe-Ni alloy from an \niron-nickel oxalate precursor. The coprecipitation method was employed to prepare oxalate precursors, \nfollowed by controlled thermal decomposition in a reducing hydrogen atmosphere. The morphology and \nproperties of the resulting particles were analysed using scanning electron microscopy (SEM) coupled with \nenergy dispersive X-ray spectroscopy (EDX), X-ray diffraction (XRD), Mössbauer spectroscopy (MS), and \nmagnetic measurements.\nThe SEM analysis revealed that the particles have approximately cube-shaped unit cell morphology with a\nsize in a range of 1 - 2 μm. Upon annealing, the samples contain multiple phases with varying Fe-Ni content.\nMagnetic measurements confirmed the formation of magnetically suitable Fe-Ni phases in the samples after \nannealing. Mössbauer spectroscopy emerged as a highly effective method for characterizing individual phases \nof the Fe-Ni system.
Klíčová slova:
Magnetic materials; thermal decomposition; Mössbauer spectroscopy
Plné texty jsou dostupné na jednotlivých ústavech Akademie věd ČR.
PROPERTIES OF NANOCRYSTALLINE FE-NI PARTICLES PREPARED BY THERMAL REDUCTION OF OXALATE PRECURSORS
Recent technological advancements require development of cost-effective and high-performance magnets \nwhich ideally do not contain rare earth metals or noble metals. The promising candidates are ...
EFFECT OF OXIDE DISPERSION ON ELECTRIC CONDUCTIVITY OF ROTARY SWAGED POWDER-BASED COPPER COMPOSITES
Kunčická, Lenka; Benč, Marek; Kačor, P.; Marek, M.
2024 - anglický
Copper is a very popular electro-conductive material, however, the mechanical properties of pure Cu are low. They can be typically improved by (micro)alloying, or via structure modifications introduced by optimized deformation and thermomechanical treatments. Designing a Cu-based composite, possibly strengthened by a dispersion of fine oxides, is another way how to favourably improve the strength properties of Cu. In this study, we performed mechanical alloying of a Cu powder with a powder of Al2O3 oxide, which is known to have strengthening effects on metallic materials. After mixing, we sealed the powder mixture into evacuated tubular Cu containers (i.e. cans). As for the consolidation procedure, we applied direct consolidation of the canned powders via the intensive plastic deformation method of rotary swaging, performed under warm conditions. Subsequently, we subjected the swaged conductors to measurements of electric conductivity and detailed structure observations. The results revealed that the applied swaging ratio was sufficient to fully consolidate the canned powders as the final conductor was unrecognizable from a cast alloy from the viewpoints of visual and structure assessment. In other words, the structure did not exhibit any voids or remnants of unconsolidated powder particles. The observed fine grains with homogeneous dispersion of Al2O3 oxide particles provided improvement of the mechanical properties, as proven by microhardness measurements. Moreover, the electric properties remained favourable.
Klíčová slova:
mechanical-properties; extrusion; Copper; oxide dispersion; electric conductivity; rotary swaging; microstructure
Plné texty jsou dostupné na jednotlivých ústavech Akademie věd ČR.
EFFECT OF OXIDE DISPERSION ON ELECTRIC CONDUCTIVITY OF ROTARY SWAGED POWDER-BASED COPPER COMPOSITES
Copper is a very popular electro-conductive material, however, the mechanical properties of pure Cu are low. They can be typically improved by (micro)alloying, or via structure modifications ...
Modification of cooling system for laboratory measurement of rotor blade vibration
Maturkanič, Dušan; Procházka, Pavel; Hodboď, Robert; Voronova, Evgeniya; Mekhalfia, Mohammed Lamine
2024 - anglický
Last year, the replacement of the turbine wheel model was completed in the Laboratory of Rotational Laser Vibrometry of the Institute of Thermomechanics AS CR, v.v.i. Based on previous experience and the expected higher operating load planned for the new wheel, the cooling system was modified at the same time. The paper describes the main effort in this direction and the results that clarify the previous damage of the measuring device.
Klíčová slova:
blade; vibration; cooling system; measurement; laboratory
Plné texty jsou dostupné na jednotlivých ústavech Akademie věd ČR.
Modification of cooling system for laboratory measurement of rotor blade vibration
Last year, the replacement of the turbine wheel model was completed in the Laboratory of Rotational Laser Vibrometry of the Institute of Thermomechanics AS CR, v.v.i. Based on previous experience and ...
DYNAMICS OF MACHINES AND MECHANICAL SYSTEMS WITH INTERACTIONS : PROCEEDINGS DYMAMESI 2024
Zolotarev, Igor; Pešek, Luděk; Kozień, M. S.
2024 - anglický
The aim of the DYMAMESI is to facilitate the exchange of up to date information and knowledge among specialists in structural and multibody dynamics, in coupled interacting systems as aero-elasticity, hydro-elasticity, biomechanics, systems with feedbacks and mechatronics. In 2023 will be hosted by Cracow University of Technology, Institute of Applied Mechanics, Section of Dynamics of Systems.
Klíčová slova:
dynamics; vibrations of mechanical systems; vibrodiagnostics; energy transformations
Plné texty jsou dostupné na jednotlivých ústavech Akademie věd ČR.
DYNAMICS OF MACHINES AND MECHANICAL SYSTEMS WITH INTERACTIONS : PROCEEDINGS DYMAMESI 2024
The aim of the DYMAMESI is to facilitate the exchange of up to date information and knowledge among specialists in structural and multibody dynamics, in coupled interacting systems as aero-elasticity, ...
NUŠL poskytuje centrální přístup k informacím o šedé literatuře vznikající v ČR v oblastech vědy, výzkumu a vzdělávání. Více informací o šedé literatuře a NUŠL najdete na webu služby.
Vaše náměty a připomínky posílejte na email nusl@techlib.cz
Provozovatel
Zahraniční báze