Ne (3138)
Ano (81)
Počet nalezených dokumentů:
3219
Publikováno od
do
Annular Impinging Jets and an Active Control of Hysteretic Effects
Devani, Yogendrasasidhar; Antošová, Zuzana; Trávníček, Zdeněk
2023 - anglický
An annular impinging air jet with and without flow control was studied experimentally using measurements of the wall pressure and flow velocity by the Pitot probe. To investigate flow control swirling effects, eight synthetic jets were generated from the nozzle center body. The experiments cover Reynolds numbers 4000–10,000 (evaluated from the outer exit diameter of the annular nozzle). For Re<9000, the bistability and hysteresis were identified and two different flow field patterns (A, B) were found under the same boundary conditions. For higher Re>9000, the hysteresis were not found.
Klíčová slova:
annular jet; impinging jet; hysteresis
Plné texty jsou dostupné na jednotlivých ústavech Akademie věd ČR.
Annular Impinging Jets and an Active Control of Hysteretic Effects
An annular impinging air jet with and without flow control was studied experimentally using measurements of the wall pressure and flow velocity by the Pitot probe. To investigate flow control swirling ...
Souvislost mezi principem nejmenší akce a termodynamickou podmínkou stability
Maršík, František; Trávníček, Zdeněk; Antošová, Zuzana
2023 - anglický
The extended principle is formulated for a material point (M.P.) X, which has nonzero mass, temperature, and trajectory x(X,t). The Lagrangian of this variation principle is equal to the kinetic energy from which, the internal energy of the material point (which depends on the entropy) and the additional energy caused by the frictional force are subtracted. The relation between the inertial force and the entropy gradient is found and the gravitational force is completely replaced by the entropy gradient. Thanks to the mentioned properties of the total enthalpy, the Thermodynamic criterion of stability of the state of M.P., is formulated.
Klíčová slova:
principle of the least action; thermodynamic stability condition; annular swirl flow
Dokument je dostupný na externích webových stránkách.
Souvislost mezi principem nejmenší akce a termodynamickou podmínkou stability
The extended principle is formulated for a material point (M.P.) X, which has nonzero mass, temperature, and trajectory x(X,t). The Lagrangian of this variation principle is equal to the kinetic ...
A new blade cascade for flutter studies
Šnábl, Pavel; Pešek, Luděk; Procházka, Pavel P.; Skála, V.
2023 - anglický
In this paper, a new blade cascade, developed in the Institute of Thermomechanics, is presented. The geometry of the cascade was modified so now the stall flutter can occur. It has some major construction improvements over the original cascade which now allow more precise and reliable measurements. The stability of the new blade cascade with five NACA 0010 profiles with rotational degree of freedom is assessed by Travelling Wave Mode approach and Aerodynamic Influence Coefficient approach.
Klíčová slova:
blade cascade; stability; travelling wave mode; aerodynamic influence coefficient
Plné texty jsou dostupné na jednotlivých ústavech Akademie věd ČR.
A new blade cascade for flutter studies
In this paper, a new blade cascade, developed in the Institute of Thermomechanics, is presented. The geometry of the cascade was modified so now the stall flutter can occur. It has some major ...
Aerodynamic Measurements on Subsonic Compressor Blade Cascades KR-D-7 and KR-D-8
Šimurda, David; Hála, Jindřich; Luxa, Martin; Radnic, Tomáš
2023 - anglický
This report contains results and evaluation of aerodynamic measurements conducted on two variant subsonic compressor blade cascades with MCA profile (KR-D-7) and DCA profile (KR-D-8) at transonic flow regimes.
Klíčová slova:
compressor blade cascade; experiment; transonic flow; subsonic flow; MCA profile; DCA profile
Plné texty jsou dostupné na jednotlivých ústavech Akademie věd ČR.
Aerodynamic Measurements on Subsonic Compressor Blade Cascades KR-D-7 and KR-D-8
This report contains results and evaluation of aerodynamic measurements conducted on two variant subsonic compressor blade cascades with MCA profile (KR-D-7) and DCA profile (KR-D-8) at transonic flow ...
Aerodynamic Measurements on Transonic Compressor Blade Cascades KR-D-9 and KR-D-10
Šimurda, David; Hála, Jindřich; Luxa, Martin
2023 - anglický
This report contains results and evaluation of aerodynamic measurements conducted on two variant transonic compressor blade cascades with MCA profile (KR-D-10) and DCA profile (KR-D-9) at transonic flow regimes.
Klíčová slova:
compressor blade cascade; experiment; transonic flow; MCA profile; DCA profile
Plné texty jsou dostupné na jednotlivých ústavech Akademie věd ČR.
Aerodynamic Measurements on Transonic Compressor Blade Cascades KR-D-9 and KR-D-10
This report contains results and evaluation of aerodynamic measurements conducted on two variant transonic compressor blade cascades with MCA profile (KR-D-10) and DCA profile (KR-D-9) at transonic ...
A short study on self-balancing of vertical rotors mounted in passive contactless bearings
Zapoměl, Jaroslav; Kozánek, Jan
2023 - anglický
Energy losses and wear of the support elements of high-speed rotors can be reduced by mounting the rotors in stable passive contactless bearings, the operation of which is based on magnetic levitation. The goal of the conducted research was to investigate applicability of selfbalancing device added to vertical rotors supported by bearings showing low stiffness and damping, which is a specific property of passive magnetic bearings. This paper deals with applicability and efficiency of self-balancing devices added to vertical rotors supported by bearings having very low stiffness and damping, which corresponds to the properties of magnetic frictionless bearings.
Klíčová slova:
self-balancing of rotors; passive contactless bearings; the influence of external damping
Plné texty jsou dostupné na jednotlivých ústavech Akademie věd ČR.
A short study on self-balancing of vertical rotors mounted in passive contactless bearings
Energy losses and wear of the support elements of high-speed rotors can be reduced by mounting the rotors in stable passive contactless bearings, the operation of which is based on magnetic ...
Dynamic tensile experiments of hard rubber on instron test machine under finite deformations
Šulc, Petr; Pešek, Luděk; Bula, Vítězslav; Šnábl, Pavel
2023 - anglický
This paper deals with the first experimental tests of hard rubbers under tensile harmonic loading on the axial-torsional servohydraulic Instron 8852 test machine. The objective of these experiments on cylindrical rubber specimens on this machine is to obtain stress-strain curves of rubber specimens, first considering uniaxial finite longitudinal strains for a single load cycle. Next, the hysteresis loops and their skeleton curves are compared for two selected strain measures as a function of their conjugate stress. It is shown how to obtain the dependence between elongation in the axial direction and constriction in the radial direction, which is used to determine the Cauchy stress in this configuration.
Klíčová slova:
uniaxial harmonic loading; finite deformation; second Piola-Kirchhoff stress; hysteresis loop; Green-Lagrange strain tensor
Plné texty jsou dostupné na jednotlivých ústavech Akademie věd ČR.
Dynamic tensile experiments of hard rubber on instron test machine under finite deformations
This paper deals with the first experimental tests of hard rubbers under tensile harmonic loading on the axial-torsional servohydraulic Instron 8852 test machine. The objective of these experiments on ...
Deep learning methods for the acoustic emission methods to evaluate an onset of plastic straining
Parma, Slavomír; Kovanda, Martin; Chlada, Milan; Štefan, Jan; Kober, Jan; Feigenbaum, H. P.; Plešek, Jiří
2023 - anglický
Development of phenomenological plasticity models, hardening rules, and plasticity theories relies on experimental data of plastic straining. The experimental data are usually measured as the stress–strain response of the material being loaded and do not provide any clues or information about the local response of\nmaterial. In this paper, we analyze the plastic deformation of the material using the acoustic emission method and current state-of-the-art neural network models such as the InceptionTime architecture.
Klíčová slova:
metal plasticity; strain hardening; acoustic emission; neural networks
Dokument je dostupný na externích webových stránkách.
Deep learning methods for the acoustic emission methods to evaluate an onset of plastic straining
Development of phenomenological plasticity models, hardening rules, and plasticity theories relies on experimental data of plastic straining. The experimental data are usually measured as the ...
Model order reduction for particle-laden flows: systems with rotations and discrete transport operators
Kovárnová, A.; Isoz, Martin
2023 - anglický
In the present work, we concentrate on particle-laden flows as an example of industry-relevant transport-dominated systems. Our previously-developed framework for data-driven model order reduction (MOR) of such systems, the shifted proper orthogonal decomposition with interpolation via artificial neural networks, is further extended by improving the handling of general transport operators. First, even with intrusive MOR approaches, the underlying numerical solvers can provide only discrete realizations of transports linked to the movement of individual particles in the system. On the other hand, our MOR methodology requires continuous transport operators. Thus, the original framework was extended by the possibility to reconstruct continuous approximations of known discrete transports via another artificial neural network. Second, the treatment of rotation-comprising transports was significantly improved.
Klíčová slova:
model order reduction; shifted POD; artificial neural networks; CFD-DEM; Open- FOAM
Dokument je dostupný na externích webových stránkách.
Model order reduction for particle-laden flows: systems with rotations and discrete transport operators
In the present work, we concentrate on particle-laden flows as an example of industry-relevant transport-dominated systems. Our previously-developed framework for data-driven model order reduction ...
Předběžné výsledky měření na HVAC jednotce pro H2-Bus s chladivy R454C a R513A
Blahut, Aleš; Kordík, Jozef; Šulc, V.; Vinš, Václav
2023 - český
Technická zpráva shrnuje předběžné vyhodnocení experimentálních zkoušek chladící jednotky a tepelného čerpadla (HVAC) pro vodíkový autobus s chladivy R454C a R513A. V klimakomoře Elektrotechnického zkušebního ústavu, s. p. v Praze Troji byla v říjnu 2023 podrobně testována zkušební HVAC jednotka v režimech klimatizace a tepelného čerpadla při teplotách okolí od -25 °C do +45 °C. Ve zprávě jsou analyzovány základní výkonové parametry HVAC jednotky zahrnující topný a chladící výkon na kondenzátoru, resp. výparníku, topné a chladící faktory okruhu a izoentropickou účinnost kompresoru.
Plné texty jsou dostupné na jednotlivých ústavech Akademie věd ČR.
Předběžné výsledky měření na HVAC jednotce pro H2-Bus s chladivy R454C a R513A
Technická zpráva shrnuje předběžné vyhodnocení experimentálních zkoušek chladící jednotky a tepelného čerpadla (HVAC) pro vodíkový autobus s chladivy R454C a R513A. V klimakomoře Elektrotechnického ...
NUŠL poskytuje centrální přístup k informacím o šedé literatuře vznikající v ČR v oblastech vědy, výzkumu a vzdělávání. Více informací o šedé literatuře a NUŠL najdete na webu služby.
Vaše náměty a připomínky posílejte na email nusl@techlib.cz
Provozovatel
Zahraniční báze